Printers & print bed¶
First select the printer manufacturer and then the model in Settings. Only models from that manufacturer are listed. Alternatively, use Manual to enter the build volume length, width and height in mm. Scale selection is enabled only when the build volume is complete.
Print targets¶
Settings → Print target offers Bambu Studio, OrcaSlicer, PrusaSlicer, Neutral 3MF, STL export, and STEP when enabled. Tiles are evenly spread across the panel. Unsupported slicers remain visible but disabled. Manual build volume supports neutral print formats and STEP when enabled. Nozzle and layer height occupy equal-width columns below and apply to supported slicer profiles.
Printer selection¶
First select the printer manufacturer and then the model in Settings. Only models from that manufacturer are listed. Alternatively, use Manual to enter the build volume length, width and height in mm. Scale selection is enabled only when the build volume is complete.
Nozzle¶
Initial setup preselects a 0.4 mm nozzle and a 0.16 mm main layer height. Choose a nozzle supported by the device. Valid saved choices remain unchanged.
Layer height¶
| Nozzle | Main body | First half | Final half |
|---|---|---|---|
| 0.2 mm | 0.08 / 0.12 mm | — | — |
| 0.4 mm | 0.16 / 0.20 / 0.24 mm | 0.16 mm | 0.12 mm |
| 0.6 mm | 0.18 / 0.24 / 0.30 mm | 0.18 mm | 0.12 mm |
| 0.8 mm | 0.24 / 0.32 / 0.40 mm | 0.24 mm | 0.16 mm |
The main layer height remains selectable. Automatic surface regions apply only to flat-printed BM exterior walls and roof panels. The start is one final fine layer below the nominal exterior plane behind the relief: 0.12 mm for 0.4/0.6 mm nozzles, 0.16 mm for 0.8 mm. The height from there to the part top is divided equally. The first half uses the intermediate layer, the final half the finest layer in the table. This divides height, not layer count.
Doors, other parts, HM/MM and vertical or inclined exterior faces have no such regions. The 0.2 mm nozzle has no automatic surface region. An unsupported device remains selectable and exports the chosen main layers without the surface steps; the app shows a notice. Precise Z height can adjust closing layers to the exact height.
Build volume¶
STL export provides meshes in mm, grouped by part type and build plate. It uses the build volume from Settings. BM allows regular component splitting; MM keeps every part intact.
Does it all fit on the bed?¶
Choose BM, HM or MM using the model icons in Export. BM and HM are available through 1:99; from 1:100, MM is used. Selecting a model does not start a build-volume check. The actual export checks the calculated print parts against the selected build volume. MM parts are not split. If a part overhangs, PrintHaus shows its actual dimensions and asks whether to export unchanged.
Excluded areas defined by the selected printer profile must remain completely clear. If a placed print part intrudes into one, export stops without a download; confirming exceeded build-volume dimensions cannot override this restriction. Neutral 3MF and STL remain free of embedded slicer profiles; their placement still respects the excluded areas of the selected printer.